Active holder with cig-plug

Active holder with cig-plug

Samsung Galaxy Tab Active 4 Pro

EAN: 7320287123296
Cikkszám: 712329
Bruttó ár:  65 723.-HUF
Mennyiség:
1
Összehasonlítás:

Az alábbiakkal kompatibilis

Samsung Galaxy Tab Active 4 Pro
Samsung Galaxy Tab Active 4 Pro SM-T630/SM-T636

Telepítési útmutató

install-image-1
1. ábra
install-image-2
2. ábra
install-image-3
3. ábra
install-image-4
4. ábra
Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. Connect device via USB Host. Press the cable into the socket, place the cable socket over the pre-drilled holes, screw the cable socket with the enclosed screws.
 
2. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
 
3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
 
4. The holder is in place.

Termékinformáció

Fits for devices with original skin. Module Upgrade Cradle. With Easy-switching system and USB Host.
Use an active holder for your Galaxy Tab Active 4 Pro while driving and you will always have a freshly charged battery! The holder provides a neat and comfortable installation - safe and convenient. The holder is equipped with a cig-plug for connection to the vehicle's 12/24 Volt socket. 3A charging. Charging via pogo plug. The holder is equipped with a USB-Host port so you can connect an accessory. The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden.   Easy-switching system: The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.   This is a Module Upgrade Cradle, this means that you can upgrade or replace features by using some of the following modules: Item no. 216329 Spring stud lock Item no. 216328 Key lock   Choose installation placement with care, devices must not be placed in positions where they may block the view or important controls. The cradle should only be attached onto a suitable place. Installations always take place at the customer's own discretion and responsibility.    

Hasonló termékek